Description

The Kidde KN-COSM-BA battery-operated carbon monoxide and smoke alarm combines two important safety devices into a single unit. This alarm includes a voice warning system that makes four announcements: fire, carbon monoxide, low battery, or smart hush activation. The voice alarm eliminates any confusion and clearly warns you and your family of a smoke or carbon monoxide danger, or if your battery is in need of replacement. This unit uses three AA batteries, protecting you and your family even throughout a power outage. This alarm uses ionization-sensing technology for the smoke alarm. Ionization-sensing alarms may detect invisible fire particles (associated with flaming fires) sooner than photoelectric alarms. Photoelectric-sensing alarms may detect visible particles (associated with smoldering fires) sooner than ionization alarms. Kidde strongly recommends that both ionization and photoelectric smoke alarms be installed to help ensure maximum detection of the more than a few types of fire that can occur within the home. KN-COSM-BA Battery-Operated Combination Smoke and CO Alarm at a Glance Employs both smoke and carbon monoxide sensors Stand-alone battery-operated alarm is easy to install during the home, as no wiring is needed Features a hush button to silence the alarm for non-emergency situations like a smoky dinner Voice alarm eliminates confusion and clearly warns of smoke/CO danger or low battery Protects from two different hazards, smoke and carbon monoxide, and has a different voice warning for each hazard. View larger. The battery-operated KN-COSM-BA offers easy installation. View larger. Combination Smoke/Carbon Monoxide Alarm The Kidde combination carbon monoxide and smoke alarm includes a voice warning system that eliminates confusion and clearly warns you and your family of a smoke or carbon monoxide (CO) danger, of low battery, or of hush-mode setting. Alarm Warnings Fire: The red LED will flash and be accompanied by three long alarm beeps followed by a verbal warning message: “Fire! Fire!” The alarm will repeat the pattern until smoke is eliminated. Carbon Monoxide: Four short alarm beeps followed by a verbal warning: “Warning–carbon monoxide!” This continues until the unit is reset or the CO is eliminated. Low Battery: One chirp followed by warning: “Low battery.” The red LED light will flash. This pattern will continue every minute for the first hour. After the first hour, the red LED light will flash once every minute and will be accompanied by the chirp sound. The low-battery warning will only sound once every 15 minutes. Voice Hush Indication: “Hush activated” and “Hush canceled” voice announcement. Peak Level Memory: If the alarm had detected a CO level of 100ppm or higher when the test/reset button is pressed, the unit will announce, “Carbon monoxide previously detected” to warn of the CO incident. Trademarked Hush Feature for Convenience By pressing the hush button, you’ll easily and safely silence nuisance alarms caused by non-emergency situations, such as overcooked dinners. This feature desensitizes the alarm for approximately 10 minutes. If the smoke is not too dense, the alarm will silence immediately, the unit will verbally announce, “Hush mode activated,” and the green LED will flash every two seconds for approximately 10 minutes. Reliable Battery Power, Indicator LED, Test Feature and Low-Battery Warning The battery-powered alarm provides continuous protection, even throughout power outages. Because this alarm only helps protect you if it’s working, this unit features a red LED that flashes every 30 to 40 seconds to indicate that it is operating accurately. For additional peace of mind, the alarm also contains a test/reset button that enables you to periodically test its circuitry and horn. If any form of battery failure is detected, the red LED light will flash and the unit will chirp one time, followed by the warning message, “low battery.” This cycle will occur once every minute, and will continue for a minimum of seven days. Seven years after initial power up, this unit will chirp” every 30 seconds. This is an operational end-of-life feature on the way to indicate that it’s time to replace the alarm. UL 2034, the independent standard applicable to CO alarms, requires CO alarms to have an end-of-life warning. This requirement went into effect in March 2007, meaning any CO alarm manufactured after April 2007 with a UL listing should have this feature. Most states that require CO alarms in residential dwellings mandate that the alarm meet the UL 2034 standard. The unit measures just 5.75 inches in diameter and 1.7 inches deep, and it features a neutral white finish. It includes tamper-resistant features to deter vandalism or theft. This combination smoke/CO alarm is UL listed, so you’ll be confident of its quality, and it is backed by a ten-year limited warranty. About Kidde: A UTC Fire and Security Brand Renowned for global leadership in fire detection and suppression, Kidde provides solutions ranging from portable fire extinguishers to advanced industrial controls such as flame detection and explosion suppression systems. Kidde is a UTC Fire and Security brand, with a history that’s rich with innovations, from the patent of the Chubb detector lock in 1818 to the development of the world’s first wireless networked smoke detectors in 2004. What’s in the Box Combination smoke and carbon monoxide alarm with mounting bracket and mounting hardware, three AA batteries, a and bilingual (English/Spanish) user’s manual.
Talking Alarm announces the hazard type detected helping to speed up the reaction time. The date on the back of the product is the manufacture date, not the expiration date.
A single unit can be installed where previously two were needed
Battery Safeguard ensures the unit cannot be by accident mounted without batteries installed
Test Reset Button tests alarm circuitry and triggers the voice announcement
Kidde?s smoke alarms and carbon monoxide detectors meet the requirements of Underwriters Laboratories (UL), an independent facility that tests products for compliance with widely-accepted safety standards